Quatra deck mounted diverter

The Quatra deck mounted three outlet diverter is fitted to a bath rim, often used with Metro hot / cold deck mounted panel valves.
The diverter has two ¾ “ inlets (hot and cold), but can be used with only one inlet for pre-mixed water from a mixer (the water is already warm : in this case use only one inlet, capping the other off with a ¾ “ BSP stop end blanking plug). There are three outlets – one is a ¾ “ outlet used for filling the bath, and the other two are ½ “ used for shower heads etc.
These are normally used to supply a bath filler, a deck mounted shower head (such as our Wash Away), and a wall mounted shower head. Most commonly only two outlets are used, with the third capped off with a ½ “ BSP blanking plug.
The diverter is 92mm wide; in addition space must be allowed for fitting the flexible connector hoses. We recommend that the diverter be used with 600mm long flexible connectors, with a ½ “ BSP male thread at one end, and either a male or female ½ “ BSP thread on the other.
The diverter must be located in the corner of a bath, or on a tap mounting ledge of at least 120mm (such as with our Pool or London baths). It must be located in the opposite corner of the hot / cold panel valves to make installation easy. We do not recommend the use of a deck mounted diverter with our freestanding baths with surround panel, with steel baths or our Soho acrylic bath.

To see recommended baths and positions for diverter locations please Click Here.

This is a solid brass fitting with a polished chrome finish to match our taps. The minimum pressure required is 1 bar to ensure an adequate flow rate.

Cartridges are WRAS approved and come with a 12 month guarantee.

The Brass body and Chrome plating come with a 10 year guarantee.

Manufactured from brass so they will not rust.

Requires minimum of 1 bar pressure.